Take the 2-minute tour ×
The Great Outdoors Stack Exchange is a question and answer site for people who love outdoor activities, excursions, and outdoorsmanship. It's 100% free, no registration required.

For my first aid kit, all of the medications are repackaged. I use nalgene snaptop vials like these.

enter image description here

I have found that even permanent sharpie marker rubs off fairly quickly when hiking. I can usually recognized the difference between medicine, but I may not be the one pulling out the kit.

What system can I use to label containers so that it will not rub off?

share|improve this question
2  
Have you considered to write on a paper and put it inside these small tubs so it can be seen without opening the tube ? –  Amine Nov 26 '12 at 15:33
    
Amine -- They are pseudo opaque, but I'd try it. I had not considered/thought of that. Post as answer? –  Russell Steen Nov 26 '12 at 15:47
add comment

5 Answers

up vote 7 down vote accepted

My favorite for this is Clear Duct Tape. Put down one piece of tape, write on it with your permanent marker, and put another layer on top of it. You don't have to worry about the ink rubbing off and if you change what's in it you can swap tape easily.

share|improve this answer
    
I like this a lot. Similar to Olin's tape over method but with the advantage of being removable if I change the use of the container. –  Russell Steen Dec 6 '12 at 15:16
add comment

I've personally found paint pens to work quite well. You can find them at Wal-Mart in the craft section and most likely any craft store. They are the brand "Painters" made by Elmer's. I use the ones with fine tips for labeling, which is slightly more defined than a Sharpie. They also come in a variety of colors so you could even color code different medicines if you so desire.

enter image description here

I've washed items labeled with a paint pen many times and it still holds up. It will eventually wear down, but it takes quite some time. If the surface to be labeled is glossy it helps to take a Scotch-brite pad or some fine sandpaper to scuff it up and then the paint pen label will last even longer.

share|improve this answer
add comment

I will probably use a small paper and put this latter inside the tube so it can be visible from the outside.

This solution might not be the best solution if the tube is not fully transparent or very small.

share|improve this answer
add comment

I occasionally have to label smooth plastic surfaces around the office that get handled regularly. As you say, even a sharpie mark wears off after a while.

What I do is to write the label with a sharpie, then put a piece of tape over it. Don't use the clear "scotch" tape, but the more permanent milky kind. Make sure it is well stuck down with no air bubbles (rub with fingernail as needed), and it should stay on nicely for a long time even in moist conditions.

share|improve this answer
add comment

I use tape medical plaster for labeling tubes: wrap your tube in it and then write over using a pen or permament marker. The plaster just makes the surface less smooth and the writing can't be rubbed of that easily. It's not waterproof, though.

The other idea which has just occured to me is to use some sharp object to carve your lables in plastic. So even if the marker paint goes off, you'll be able to read the label.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.