Reputation
Top tag
Next privilege 75 Rep.
Set bounties
Badges
10
Impact
~496 people reached

May
3
comment How to overcome fear of falling in lead climbing
Dear downvoter, please leave a comment.
Apr
26
answered How to overcome fear of falling in lead climbing
Sep
24
awarded  Autobiographer
Jul
18
revised Learning to fall when leading: what is good fall technique?
Bolded some words
Jul
18
suggested approved edit on Learning to fall when leading: what is good fall technique?
Jul
18
comment Learning to fall when leading: what is good fall technique?
+1 for take it and keep it clean. Dive folks, just dive :-)
Jul
18
comment Selecting a hammer drill for bolting climbs
Thanks for the details. Some references, would be appreciated though.
Jul
18
awarded  Benefactor
Jul
18
awarded  Scholar
Jul
18
accepted Selecting a hammer drill for bolting climbs
Jul
18
awarded  Commentator
Jul
18
comment Selecting a hammer drill for bolting climbs
@Liam Sure, I wanted to wait, as much as possible.
Jul
17
revised Selecting a hammer drill for bolting climbs
Structured
Jul
17
suggested approved edit on Selecting a hammer drill for bolting climbs
Jul
15
comment Selecting a hammer drill for bolting climbs
Do you mind if I edit your post a bit and put some headings in-between of paragraphs?
Jul
11
awarded  Promoter
Jul
11
revised Selecting a hammer drill for bolting climbs
questions limited to SDS shank compatible hammer drills
Jul
10
comment Selecting a hammer drill for bolting climbs
Although I cannot accept this reply as an answer, I did not downvote it. I would appreciate it if the downvoter leaves a comment.
Jul
10
comment Selecting a hammer drill for bolting climbs
@BenediktBauer Sure, once I get some time to edit, I will improve/simplify the question(s) further.
Jul
7
comment Selecting a hammer drill for bolting climbs
This answer doesn't address the questions asked. It helps, perhaps, in improving the question. Asked are, as precise as possible, scientifically accurate explanations, for (the most) important technical characteristics of a hammer drill. E.g. why RPM should range between 0 and X and why it should not be above Y, or similar. For sure, depending on the type of the rock, the answers will differ accordingly. Thank you, however, for your time and sharing your experience.